[1]刘永志,李岩,井永腾,等.基于Fluent软件的电力变压器温度场计算与分析[J].中国计划生育和妇产科,2012,(10):6-9.
　LIU Yong-zhi,LI Yan,JING Yong-teng.Calculation and Analysis of Temperature Field of Power Transformer Based on Software Fluent[J].Chinese Journal of Family Planning & Gynecotokology,2012,(10):6-9.
点击复制

基于Fluent软件的电力变压器温度场计算与分析
分享到：

《中国计划生育和妇产科》[ISSN:1674-4020/CN:51-1708/R]

卷:
期数:
2012年10期
页码:
6-9
栏目:
研究与分析
出版日期:
2012-10-30

文章信息/Info

Title:
Calculation and Analysis of Temperature Field of Power Transformer Based on Software Fluent
作者:
刘永志;李岩;井永腾;
沈阳工业大学特种电机研究所
Author(s):
LIU Yong-zhi; LI Yan; JING Yong-teng
Research Institution of Special Machines,Shenyang University of Technology,Shenyang 110870,China
关键词:
电力变压器;  温度场;  热点温升
Keywords:
power transformer;  temperature field;  hot-point temperature-rise
分类号:
TM41
摘要:
温升是设计变压器时需控制的一项重要性能参数,同时也是考核变压器寿命的一项关键性指标。因此,准确地计算出温升对变压器运行的可靠性及生产成本的经济性都有重要的作用。笔者应用Fluent软件计算了自然油循环电力变压器的温度场,将仿真结果与解析结果进行了对比,在此基础上分析了水平油道高度、导向区数、发热中心与散热中心高度之比、负载系数对绕组平均温升和热点温升的影响,并给出了在设计时应综合考虑导向区数和安装散热器时在条件允许的情况下应尽可能的安装在比较高的位置以降低绕组的热点温升与平均温升的结论。
Abstract:
Temperature-rise is an important performance parameter in design of transformer,and is also the key index in examining transformer life.To accurately obtain temperature-rise of a transformer,temperature field of a natural oil circulation power transformer is calculated by CFD software FLUENT in this paper.Simulation results and analytical calculation results are compared.Then the influences of horizontal duct height,number of discs, ratio of heat center to thermal center heigh,and load coefficient on the winding’s average temperature-rise and hot-point temperature-rise are analyzed.Conclusion is drawn that in design of this kind of transformer,number of discs ought to be considered comprehensively,and radiator ought to be arranged at higher position to reduce the average temperature-rise and hot-point temperature-rise of winding.

参考文献/References:

[1]张安红,刘军.180 MV·A/220 kV电力变压器负载损耗超标分析[J].变压器,2004,41(8):1-6. ZHANG An-hong,LIU Jun.Overproof analysis of on-load loss in 180 MV-A/220 kV power transformer[J].Transformer, 2004,41(8):1-6. [2]谢毓城.电力变压器手册[M].北京:机械工业出版社, 2003. XIE Yu-cheng.Power transformer handbook[M].Beijing: Chine Machine Press,2003. [3]王秀春,俞昌铭.强油导向冷却结构变压器中导向油流量和温升计算[J].中国电机工程学报,1991,11(3):43-50. WANG Xiu-chun,YU Chang-ming.Calculation of the directed oil flows and oil temperature rise in a power transformer at forced- directed circulation[J].Proceedings of the CSEE,1991,11(3):43-50. [4]贾子瑜,姚日琪,王秀莲.强油导向冷却电力变压器的油流工程计算方法[J].变压器,1998,35(2):34-37. JIA Zi-yu,YAO Ri-qi,WANG Xiu-lian.Engineering calculation method of oil flow distribution for ODAF power transformer[J].Transformer,1998,35(2):34-37. [5]VECCHIO R M D.FEGHALI P.Thermal model of a disk coil with directed oil flow[C]//1999 IEEE Transmission and Distribution Conference.[S.l.]:IEEE,1999:914-919. [6]江淘莎,李剑,陈伟根,等.油浸式变压器绕组热点温度计算的热路模型[J].高电压技术,2009,35(7):1635-1640. JIANG Tao-sha,LI Jian.CHEN Wei-gen,et al.Thermal model for hot spot temperature calculation in oil-immersed transformers[J].High Voltage Engineering,2009,35(7): 1635-1640. [7]RADAKOVIC Z.FESER K.A new method for the calculation of the hot-spot temperature in power transformers with ONAN cooling[J].IEEE Trans,on Power Delivery,2003, 18(4):1284-1292. [8]汤炎,刘成远,郝忠言,等.变压器绕组热点温升的计算与实验研究[J].变压器,2001,38(2):1-5. TANG Yan.LIU Cheng-yuan,HAO Zhong-yan.et al. Calculation and test of hot-point temperature-rise in transformer windings[J].Transformer,2001,38(2):1-5. [9]傅晨钊,汲胜昌,王世山,等.变压器绕组温度场的二维数值计算[J].高电压技术,2002,28(5):10-12. FU Chen-zhao,JI Sheng-chang,WANG Shi-shan,et al.2D numerical calculation of temperature field of winding in transformer[J].High Voltage Engineering,2002,28(5):10-12. [10]傅晨钊,李清泉,王世山,等.电缆绕组变压器绕组温度场的二维数值计算[J].电工电能新技术,2002,21(4):45-50. FU Chen-zhao,LI Qing-quan,WANG Shi-shan,et al.2D numerical calculation of temperature field of winding in cable winding transformer[J].Advanced Technology of Electrical Engineering and Energy,2002,21(4):45-50. [11]王秀春,陶军普.大型自然油循环导向冷却变压器温度场研究[J].变压器,2008,45(7):6-10. WANG Xiu-chun,TAO Jun-pu.Temperature field research of large forced-directed oil cooling tansformer[J]. Transformer,2008,45(7):6-10. [12]王秀春,刘伟军,朱恒宣,等.油浸式变压器层式绕组温度场研究[J].变压器,2010,47(10):44-48. WANG Xiu-chun,LIU Wei-jun,ZHU Heng-xuan,et al. Research on temperature field of layer-type winding in oilimmersed transformer[J].Transformer,2010,47(10):44-48. [13]杨珏,贾宝山.方腔内20-720 K温差下自然对流变物性模型[J].清华大学学报:自然科学版,2003,43(12): 1597-1600. YANG JueJIA Bao-shan.Variable property model for natural convection in a square cavity with temperature differences of 20-720 K[J].Journal of Tsinghua University: Science and Technology,2003,43(12):1597-1600. [14]温波,刘爽,冯加奇,等.油浸式电力变压器绕组温度场的二维仿真分析[J].变压器,2009,46(9):35-38. WEN Bo,LIU Shuang.FENG Jia-qi,et al.Two dimensional simulation analysis of winding temperature fieid of oilimmersed power tansformer[J].Transformer,2009,46(9): 35-38. [15]陶文铨.数值传热学(2版)[M].西安:西安交通大学出版社.2001. TAO Wen-quan.Numerical heat transfer(second edition)[M]- Xi' an:Xi' an Jiaotong University Press,2001. [16]井永腾.电力变压器涡流场及热问题计算与分析[D].沈阳:沈阳工业大学,2009. JING Yong-teng.Computation and analysis of power transformer on eddy current field and hot question[D]. Shenyang:Shenyang University of Technology,2009.

备注/Memo

备注/Memo:
国家自然科学基金资助项目(51177103);辽宁省高校创新团队计划资助项目(LT2011002)~~
更新日期/Last Update: 2012-10-30